One of our Sydney Users made me aware of this little Revit funny. It is in regard to using the Callout view tool in “Reference other view” mode. If the view you are trying to reference to, does not have its “Crop View” enabled on, it will not appear in the view list.
It does not affect Section or Elevation tag cross referencing, however if you are creating a Callout in the elevation or section the above applies.
This applies to Revit 2009 and 2010. I’m not sure if this is intentional, but it is a bit stressful for users trying to figure out why they cannot reference a particular view.
No comments:
Post a Comment